2011 Chevrolet Cruze Owner's Manual - Page 312

10-66 Vehicle Care 18. Stop at a safe location and check the tire pressure. Refer to Steps 1 through 11 under "Using the Tire Sealant and Compressor Kit without Sealant to Inflate a Tire (Not Punctured)." If the tire pressure has fallen more than 68 kPa (10 psi) below the recommended inflation pressure, stop driving the vehicle. The tire is too severely damaged and the tire sealant cannot seal the tire. See Roadside Assistance Program on page 13‑6. If the tire pressure has not dropped more than 68 kPa (10 psi) from the recommended inflation pressure, inflate the tire to the recommended inflation pressure. 19. Wipe off any sealant from the wheel, tire or vehicle. 20. Dispose of the used sealant canister (B) and sealant/air hose (G) assembly at a local dealer or in accordance with local state codes and practices. 21. Replace it with a new canister available from your dealer. 22. After temporarily sealing a tire using the tire sealant and compressor kit, take the vehicle to an authorized dealer within 161 km (100 miles) of driving to have the tire repaired or replaced. 15. If the flat tire was able to inflate to the recommended inflation pressure, remove the maximum speed label from the sealant canister (B) and place it in a highly visible location. Do not exceed the speed on this label until the damaged tire is repaired or replaced. 16. Return the equipment to its original storage location in the vehicle. 17. Immediately drive the vehicle 8 km (5 miles) to distribute the sealant in the tire.