2011 Chevrolet Silverado 1500 Regular Cab Owner's Manual - Page 346

9-62 Driving and Operating 6. Turn the transfer case dial clockwise to N (Neutral) until it stops and hold it there until the N (Neutral) light starts blinking. This will take at least 10 seconds. Then slowly release the dial to the four low position. The N (Neutral) light will come on when the transfer case shift to N (Neutral) is complete. 7. If the engine is running, make sure that the transfer case is in N (Neutral) by shifting the transmission to R (Reverse) for one second, then shift the transmission to D (Drive) for one second. 8. Turn the ignition to ACC/ ACCESSORY, which will turn the engine off. 9. Place the transmission shift lever in P (Park). 10. Release the parking brake prior to moving the vehicle. 11. Turn the ignition to LOCK/OFF. Shifting Out of Neutral To shift out of N (Neutral) do the following: 1. Set the parking brake and apply the regular brake pedal. 2. Turn the ignition to ON/RUN with the engine off, and shift the transmission to N (Neutral). 3. Turn the transfer case dial to Two-Wheel Drive High, Four-Wheel Drive High, or AUTO. After the transfer case has shifted out of N (Neutral), the N (Neutral) light will go out. Shifting into Neutral To shift the transfer case to N (Neutral) do the following: 1. Make sure the vehicle is parked so that it will not roll. 2. Set the parking brake and apply the regular brake pedal. See Parking Brake on page 9‑64 for more information. 3. Shifting the transfer case into N (Neutral) can be done with or without the engine running. Shifting without the engine running should be done with the ignition in ON/RUN. 4. Put the transmission in N (Neutral). 5. Shift the transfer case to Two-Wheel Drive High.