2013 Chevrolet Tahoe Owner Manual - Page 129

Instruments and Controls strong magnetic field interfering with the compass. Such interference may be caused by a magnetic CB or cell phone antenna mount, a magnetic emergency light, magnetic note pad holder, or any other magnetic item. Turn off the vehicle, move the magnetic item, then turn on the vehicle and calibrate the compass. To calibrate the compass, use the following procedure: Compass Calibration Procedure 1. Before calibrating the compass, make sure the compass zone is set to the variance zone in which the vehicle is located. See "Compass Variance (Zone) Procedure" earlier in this section. Do not operate any switches such as window, sunroof, climate controls, or seats during the calibration procedure. 2. Press the vehicle information button until PRESS V TO CALIBRATE COMPASS displays. Or, if the vehicle does not have DIC buttons, press the trip odometer reset stem until CALIBRATE COMPASS displays. 3. Press the set/reset button to start the compass calibration. Or, if the vehicle does not have DIC buttons, press and hold the trip odometer reset stem for two seconds to start the compass calibration. 4. The DIC will display CALIBRATING: DRIVE IN CIRCLES. Drive the vehicle in tight circles at less than 8 km/h (5 mph) to complete the calibration. The DIC will display CALIBRATION COMPLETE for a few seconds when the calibration is complete. The DIC display will then return to the previous menu. 5-7 Clock To set the time and date: 1. Turn the ignition key to ACC/ ACCESSORY or ON/RUN, then press the O button to turn the radio on. 2. Press the H button to display HR, MIN, MM, DD, YYYY (hour, minute, month, day, and year). 3. Press the softkey located under any one of the tabs to change that setting. 4. To increase the time or date, do one of the following: . Press the softkey below the selected tab. ... ¨ SEEK button. Press the \ FWD button. Turn the f knob clockwise. Press the