2013 Chevrolet Tahoe Owner Manual - Page 376
2013 Chevrolet Tahoe Manual
Page 376 highlights
10-34 Vehicle Care 5. Reverse Steps 1-3 to reinstall the license plate lamp. Electrical System Electrical System Overload The vehicle has fuses and circuit breakers to protect against an electrical system overload. When the current electrical load is too heavy, the circuit breaker opens and closes, protecting the circuit until the current load returns to normal or the problem is fixed. This greatly reduces the chance of circuit overload and fire caused by electrical problems. Fuses and circuit breakers protect power devices in the vehicle. Replace a bad fuse with a new one of the identical size and rating. If there is a problem on the road and a fuse needs to be replaced, the same amperage fuse can be borrowed. Choose some feature of the vehicle that is not needed to use and replace it as soon as possible. Headlamp Wiring An electrical overload may cause the lamps to go on and off, or in some cases to remain off. Have the headlamp wiring checked right away if the lamps go on and off or remain off. Replacement Bulbs If the vehicle is a hybrid, see the hybrid supplement for more information. Bulb Exterior Lamp Number Back-up Lamp License Plate Lamp Rear Turn Signal Lamp, Taillamp, and Stoplamp Side Marker Lamp 7441 W5WLL 3057 KX RD 194 Windshield Wipers If the wiper motor overheats due to heavy snow or ice, the windshield wipers will stop until the motor cools and will then restart. Although the circuit is protected from electrical overload, overload due to heavy snow or ice may cause wiper linkage damage. Always clear ice and heavy snow from the windshield before using the windshield wipers. If the overload is caused by an electrical problem and not snow or ice, be sure to get it fixed. For replacement bulbs not listed here, contact your dealer.