2010 Dodge Nitro Owner Manual - Page 170
2010 Dodge Nitro Manual
Page 170 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 169 Gate Operator/Canadian Programming Canadian radio-frequency laws require transmitter signals to "time-out" (or quit) after several seconds of transmission - which may not be long enough for HomeLink to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to "time-out" in the same manner. successfully accepted the frequency signal. The indicator light will flash slowly and then rapidly when fully trained. If you unplugged the device for training, plug it back in at this time. Then proceed with Step 4 under "Programming HomeLink" earlier in this section. 3 It may be helpful to unplug the device during the cycling process to prevent possible overheating of the garage Using HomeLinkா To operate, press and release the programmed door or gate motor. HomeLink button. Activation will now occur for the If you are having difficulties programming a garage door trained device (i.e., garage door opener, gate operator, opener or a gate operator, replace "Programming Security system, entry door lock, home/office lighting, HomeLink" Step 3 with the following: etc.,). The handheld transmitter of the device may also be 3. Continue to press and hold the HomeLink button, used at any time. while you press and release ("cycle"), your handheld transmitter every two seconds until HomeLink has