2010 Dodge Nitro Owner Manual - Page 205
2010 Dodge Nitro Manual
Page 205 highlights
204 UNDERSTANDING YOUR INSTRUMENT PANEL A loose, improperly installed, or damaged fuel filler cap reset, this message will continue to display each time you may also turn on the Malfunction Indicator Light (MIL). turn the ignition switch to the ON/RUN position. To turn off the message temporarily, press and release the TRIP noFUSE ODOMETER button on the instrument cluster. To reset If the vehicle diagnostic system determines that the the oil change indicator system (after performing the Ignition Off Draw (IOD) fuse is improperly installed, or scheduled maintenance), refer to the following procedamaged, a "noFUSE" message will display in the odomdure: eter display area. For further information on fuses and 1. Turn the ignition switch to the ON position. Do not fuse locations refer to "Fuses" in "Maintaining Your start the engine. Vehicle". 2. Fully depress the accelerator pedal slowly three CHAngE OIL Message times within 10 seconds. Your vehicle is equipped with an engine oil change indicator system. The "CHAngE OIL" message will flash 3. Turn the ignition switch to the OFF/LOCK position. in the instrument cluster odometer for approximately 12 seconds after a single chime has sounded to indicate NOTE: If the indicator message illuminates when you the next scheduled oil change interval. The engine oil start the vehicle, the oil change indicator system did not change indicator system is duty cycle based, which reset. If necessary, repeat this procedure. means the engine oil change interval may fluctuate dependent upon your personal driving style. Unless