2010 Dodge Nitro Owner Manual - Page 311
2010 Dodge Nitro Manual
Page 311 highlights
310 STARTING AND OPERATING Shifting Procedure - Electronically Shifted Transfer Case NOTE: If any of the requirements to select a new transfer case position have not been met, the transfer case NOTE: will not shift. The "4WD Indicator Light" (located in the • The four-wheel drive system will not allow shifts between 2WD/4WD LOCK if the front and/or rear display under the tachometer) will flash until all the wheels are spinning (no traction). In this situation, the requirements for the selected position have been met. To "4WD Indicator Light" (located in the display under retry a shift, return the control knob back to the original the tachometer) will flash. At this time, reduce speed position, make certain all shift requirements have been and stop spinning the wheels to complete the shift. met, wait five seconds and try the shift again. 2WD⇔ 4WD LOCK Rotate the transfer case switch to the desired position. Shifts between 2WD and 4WD LOCK can be done with the vehicle stopped or in motion. With the vehicle in motion, the transfer case will engage/disengage faster if you momentarily release the accelerator pedal after turning the switch. If the vehicle is stopped, the ignition key must be in the ON position with the engine either RUNNING or OFF. This shift cannot be completed if the key is in the ACC position. • Delayed shifting out of 4WD LOCK may be experienced due to uneven tire wear, low tire pressure, or excessive loading. ON-ROAD DRIVING TIPS Utility vehicles have higher ground clearance and a narrower track to make them capable of performing in a wide variety of off-road applications. Specific design