2010 Dodge Nitro Owner Manual - Page 215

214 UNDERSTANDING YOUR INSTRUMENT PANEL • Right rear low pressure (with a single chime). Refer to will flash in the EVIC display for approximately 10 sec"Tire Pressure Monitoring System" in "Starting And onds after a single chime has sounded to indicate the next scheduled oil change interval. The engine oil change Operating". indicator system is duty cycle based, which means the • Check TPM System (with a single chime). Refer to engine oil change interval may fluctuate dependent upon "Tire Pressure Monitoring System" in "Starting And your personal driving style. Unless reset, this message Operating". will continue to display each time you turn the ignition • Check Gascap (refer to "Adding Fuel" in "Starting switch to the ON/RUN position. To turn off the message temporarily, press and release the MENU button. To reset And Operating"). the oil change indicator system (after performing the • Oil change required (with a single chime). scheduled maintenance) refer to the following procedure. • Park Assist Disabled 1. Turn the ignition switch to the ON position. (Do not start the engine). • Service Park Assist System (with a single chime) • ECO (Fuel Saver Indicator) - if equipped 2. Fully depress the accelerator pedal slowly three times within 10 seconds. Oil Change Required Your vehicle is equipped with an engine oil change 3. Turn the ignition switch to the OFF/LOCK position. indicator system. The "Oil Change Required" message