2010 Dodge Nitro Owner Manual - Page 195

194 UNDERSTANDING YOUR INSTRUMENT PANEL normal, turn the engine off immediately and call for 10. Electronic Stability Program (ESP) Warning Light / service. Refer to "If Your Engine Overheats" in "What To Brake Assist System (BAS) Warning Light - If Equipped Do In Emergencies" for further information. The malfunction light for the Electronic Stabil7. Speedometer ity Program (ESP) is combined with Brake Shows the vehicles speed. Assist System (BAS). The yellow "ESP/BAS Warning Light" comes on when the ignition 8. High Beam Indicator This indicator shows that the high beam head- switch is turned to the "ON" position. They should go lights are on. Push the multifunction lever forward out with the engine running. If the "ESP/BAS Warning to switch the headlights to high beam, and pull toward Light" comes on continuously with the engine running, a malfunction has been detected in either the ESP or the yourself (normal position) to return to low beam. BAS system. If this light remains on after several ignition 9. Vehicle Security Light - If Equipped cycles, and the vehicle has been driven several miles This light will flash at a fast rate for approxi(kilometers) at speeds greater than 30 mph (48 km/h), see mately 15 seconds, when the vehicle security an authorized dealer as soon as possible. alarm is arming, and then will flash slowly NOTE: The ESP Control System will make buzzing or until the vehicle is disarmed. clicking sounds when it is actively operating.