2010 Dodge Nitro Owner Manual - Page 428

MAINTAINING YOUR VEHICLE 427 Draining Fluid the vehicle. Fluid changes are not necessary unless the First remove the fill plug (1), then the drain plug (2). fluid becomes contaminated with water. Change the fluid Recommended tightening torque for the drain and fill immediately if contaminated with water. plugs is 15-25 ft lbs (20-34 N·m). Front/Rear Axle Fluid For normal service, periodic fluid level checks are not CAUTION! required. When the vehicle is serviced for other reasons Do not over-tighten the plugs. You could damage the exterior surfaces of the axle assembly should be inspected. If gear oil leakage is suspected inspect the them and cause a leak. fluid level. Refer to "Fluids, Lubricants, and Genuine Parts" in "Maintaining Your Vehicle" for further informaLubricant Selection Use only manufacturer's recommended fluid. Refer to tion. "Fluids, Lubricants, and Genuine Parts" in "Maintaining Fluid Level Check Your Vehicle" for further information. • Front axle lubricant should be at the bottom edge of Frequency of Fluid Change the oil fill hole when the vehicle is in a level position. Under normal operating conditions, the fluid installed at the factory will give satisfactory lubrication for the life of • Rear axle lubricant should be 0.5 in (11 mm) below the bottom edge of the oil fill hole when the vehicle is in a level position. 7