2013 Dodge Avenger Owner Manual - Page 187

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 185 1. Cycle the ignition to the ON/RUN position. 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink® button you wish to program while keeping the HomeLink® indicator light in view. attached to the garage door opener/device motor. Firmly press and release the "LEARN" or "TRAINING" button. On some garage door openers/devices there may be a light that blinks when the garage door opener/device is in the LEARN/TRAIN mode. NOTE: You have 30 seconds in which to initiate the next 3. Simultaneously press and hold both the HomeLink® step after the LEARN button has been pressed. button you want to program and the hand-held transmitter button. 6. Return to the vehicle and press the programmed HomeLink® button twice (holding the button for two 4. Continue to hold both buttons and observe the indiseconds each time). If the garage door opener/device cator light. The HomeLink® indicator will flash slowly activates, programming is complete. and then rapidly after HomeLink® has received the frequency signal from the hand-held transmitter. Re- NOTE: If the garage door opener/device does not actilease both buttons after the indicator light changes vate, press the button a third time (for two seconds) to from slow to rapid. complete the training. 5. At the garage door opener motor (in the garage), To program the remaining two HomeLink® buttons, locate the "LEARN" or "TRAINING" button. This can repeat each step for each remaining button. DO NOT usually be found where the hanging antenna wire is erase the channels. 3