2013 Dodge Avenger Owner Manual - Page 189

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 187 Canadian radio frequency laws require transmitter signals to time-out (or quit) after several seconds of transTo reprogram a channel that has been previously trained, mission - which may not be long enough for HomeLink® follow these steps: to pick up the signal during programming. Similar to this 1. Cycle the ignition to the ON/RUN position. Canadian law, some U.S. gate operators are designed to time-out in the same manner. 2. Press and hold the desired HomeLink® button until the indicator light begins to flash after 20 seconds. It may be helpful to unplug the device during the cycling process to prevent possible overheating of the garage Do not release the button. door or gate motor. 3. Without releasing the button proceed with "Programming A Non-Rolling Code" Step 2 and follow all 1. Cycle the ignition to the ON/RUN position. remaining steps. 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink® button you wish to proCanadian/Gate Operator Programming gram while keeping the HomeLink® indicator light in For programming transmitters in Canada/United States view. that require the transmitter signals to "time-out" after several seconds of transmission. 3. Continue to press and hold the HomeLink® button, while you press and release ("cycle"), your hand-held transmitter every two seconds until HomeLink® has Reprogramming A Single HomeLink® Button 3