2013 Dodge Avenger Owner Manual - Page 190

188 UNDERSTANDING THE FEATURES OF YOUR VEHICLE successfully accepted the frequency signal. The indi- Reprogramming A Single HomeLink® Button cator light will flash slowly and then rapidly when To reprogram a channel that has been previously trained, fully trained. follow these steps: 4. Watch for the HomeLink® indicator to change flash 1. Cycle the ignition to the ON/RUN position. rates. When it changes, it is programmed. It may take up to 30 seconds or longer in rare cases. The garage 2. Press and hold the desired HomeLink® button until the indicator light begins to flash after 20 seconds. door may open and close while you are programming. Do not release the button. 5. Press and hold the programmed HomeLink® button 3. Without releasing the button proceed with "Canaand observe the indicator light. dian/Gate Operator Programming" Step 2 and follow • If the indicator light stays on constantly, programall remaining steps. ming is complete and the garage door/device should Using HomeLink® activate when the HomeLink® button is pressed. • To program the two remaining HomeLink® buttons, To operate, press and release the programmed HomeLink® repeat each step for each remaining button. DO NOT button. Activation will now occur for the programmed erase the channels. device (i.e., garage door opener, gate operator, security If you unplugged the garage door opener/device for system, entry door lock, home/office lighting, etc.,). The hand-held transmitter of the device may also be used at programming, plug it back in at this time. any time.