2013 Dodge Avenger Owner Manual - Page 94

92 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE Installing A Child Restraint with a Switchable Automatic Locking Retractor (ALR) 1. Place the child seat in the center of the seating position. For some second row seats, you may need to 6. Try to pull the webbing out of the retractor. If it is recline the seat and/or raise the head restraint to get a locked, you should not be able to pull out any webbetter fit. bing. If the retractor is not locked, repeat step 5. 2. Pull enough of the seat belt webbing from the retractor 7. Finally, pull up on any excess webbing to tighten the to pass it through the belt path of the child restraint. lap portion around the child restraint while you push Do not twist the belt webbing in the belt path. the child restraint rearward and downward into the vehicle seat. 3. Slide the latch plate into the buckle until you hear a "click." 8. If the child restraint has a top tether strap and the seating position has a top tether anchorage, connect 4. Pull on the webbing to make the lap portion tight the tether strap to the anchorage and tighten the tether against the child seat. strap. Refer to "Lower Anchors and Tethers for Chil5. To lock the seat belt, pull down on the shoulder part of dren (LATCH) Restraint System" for directions to the belt until you have pulled all the seat belt webbing attach a tether anchor. out of the retractor. Then, allow the webbing to retract back into the retractor. As the webbing retracts, you will hear a clicking sound. This means the seat belt is now in the Automatic Locking mode.