2012 Jeep Grand Cherokee Owner Manual - Page 328

326 UNDERSTANDING YOUR INSTRUMENT PANEL been deactivated. When this feature is deactivated, the only show a visual alert in the outside mirrors. By system reverts to the standard intermittent wiper pressing and releasing the SELECT button a second time "Blind Spot: Lights/CHM" mode is activated. In this operation. mode the Blind Spot Monitor (BSM) will show a visual Hill Start Assist (HSA) alert in the outside mirrors as well as an audible alert When this feature is selected, the HSA system is active. when the turn signal is on. When "Blind Spot: Off" is Refer to "Electronic Brake Control System" in "Starting selected the Blind Spot Monitor (BSM) system is deactiAnd Operating" for system function and operating inforvated. mation. To make your selection, press and release the SELECT button until a check-mark appears next to the NOTE: If your vehicle has experienced any damage in feature showing the system has been activated or the the area where the sensor is located, even if the fascia is check-mark is removed showing the system has been not damaged, the sensor may have become misaligned. Take your vehicle to an authorized dealer to verify sensor deactivated. alignment. Having a sensor that is misaligned will result Blind Spot Alert in the BSM not operating to specification. There are three selections when operating Blind Spot Alert. By pressing and releasing the SELECT button once, Forward Collision Warning the Blind Spot Alert feature can be activated in "Blind The Forward Collision Warning (FCW) feature can be can Spot: Lights Only" mode. When this mode is selected the be set to Far, set to Near or turned Off. The default status Blind Spot Monitor (BSM) system is activated and will of FCW is the Far setting. This means the system will