2012 Jeep Grand Cherokee Owner Manual - Page 420

418 STARTING AND OPERATING NOTE: If the ignition switch is left in the ACC or RUN (engine not running) position and the transmission is in PARK, the system will automatically time out after 1. Place the shift lever in PARK, then press and release 30 minutes of inactivity and the ignition will switch to the the ENGINE START/STOP button. OFF position. 2. The ignition switch will return to the OFF position. Keyless Enter-N-Go Functions - With Driver's Foot 3. If the shift lever is not in PARK, the ENGINE START/ OFF The Brake Pedal (In PARK Or NEUTRAL STOP button must be held for two seconds and vehicle Position) speed must be above 5 mph (8 km/h) before the engine The Keyless Enter-N-Go feature operates similar to an will shut off. The ignition switch position will remain in ignition switch. It has four positions, OFF, ACC, RUN the ACC position until the shift lever is in PARK and the and START. To change the ignition switch positions button is pressed twice to the OFF position. If the shift without starting the vehicle and use the accessories lever is not in PARK and the ENGINE START/STOP follow these steps. button is pressed once, the EVIC (if equipped) will • Starting with the ignition switch in the OFF position: display a "Vehicle Not In Park" message and the engine will remain running. Never leave a vehicle out of the • Press the ENGINE START/STOP button once to change the ignition switch to the ACC position (EVIC PARK position, or it could roll. displays "IGNITION MODE ACCESSORY"), To Turn Off The Engine Using ENGINE START/STOP Button