2012 Jeep Grand Cherokee Owner Manual - Page 448

446 STARTING AND OPERATING "Electronic Vehicle Information Center (EVIC)" in 4. Hold down the NEUTRAL "pin" switch (with a pen, "Understanding Your Instrument Panel" for further etc.) for four seconds until the LED light by the switch starts to blink indicating shift in progress. The light will information. stop blinking (stay on solid) when the NEUTRAL shift is • Shifting into or out of 4WD LOW is possible with the complete. vehicle completely stopped; however, difficulty may occur due to the mating clutch teeth not being properly aligned. Several attempts may be required for clutch teeth alignment and shift completion to occur. The preferred method is with the vehicle rolling 0 to 3 mph (0 to 5 km/h). If the vehicle is moving faster than 3 mph (5 km/h), the transfer case will not allow the shift. NEUTRAL Shift Procedure 1. Turn the ignition switch to the ON position, engine off. 2. Vehicle stopped, with foot on brake. 3. Place the transmission into NEUTRAL. Neutral Switch 5. Repeat Steps 1 to 4 to shift out of NEUTRAL.