2012 Jeep Grand Cherokee Owner Manual - Page 34

32 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE • The engine can be started two consecutive times with the RKE transmitter. However, the ignition must be cycled by pushing the START/STOP button twice (or the ignition switch must be cycled to the ON/RUN position) before you can repeat the start sequence for a third cycle. equipped). Then, prior to the end of the 15 minute cycle, press and release the START/STOP button. If the START/STOP button is not present, insert the Key Fob into the ignition switch and turn the switch to the ON/RUN position. NOTE: To Exit Remote Start Mode Without Driving The • For vehicles not equipped with the Keyless EnterVehicle N-Go feature, the ignition switch must be in the Press and release the REMOTE START button one time or ON/RUN position in order to drive the vehicle. allow the engine to run for the entire 15 minute cycle. • For vehicles not equipped with the Keyless EnterN-Go feature, the message "Remote Start Active - NOTE: To avoid unintentional shutdowns, the system Insert Key and Turn To Run" will display in the EVIC will disable the one time press of the REMOTE START until you insert the key. Refer to "Electronic Vehicle button for two seconds after receiving a valid Remote Information Center (EVIC)" for further information. Start request. To Exit Remote Start Mode And Drive The Vehicle • For vehicles equipped with the Keyless Enter-N-Go Before the end of 15 minute cycle, press and release the feature, the message "Remote Start Active - Push UNLOCK button on the RKE transmitter to unlock the Start Button" will display in the EVIC until you push doors and disarm the Vehicle Security Alarm (if the START button.