2012 Jeep Grand Cherokee Owner Manual - Page 419

STARTING AND OPERATING 417 Installing And Removing The ENGINE START/STOP Button Installing The Button 1. Remove the key fob from the ignition switch. NOTE: The ENGINE START/STOP button should only be removed or inserted with the ignition in the LOCK position (OFF position for Keyless Enter-N-Go). Normal Starting Using The ENGINE START/STOP Button 2. Insert the ENGINE START/STOP button into the ignition switch with the lettering facing up and readable. NOTE: Normal starting of either a cold or a warm engine is obtained without pumping or pressing the 3. Press firmly on the center of the button to secure it into accelerator pedal. position. To start the engine, the transmission must be in PARK or Removing The Button NEUTRAL. Press and hold the brake pedal while press1. The ENGINE START/STOP button can be removed ing the ENGINE START/STOP button once. The system takes over and attempts to start the vehicle. If the vehicle from the ignition switch for key fob use. fails to start, the starter will disengage automatically after 2. Insert the metal part of the emergency key under the 10 seconds. If you wish to stop the cranking of the engine chrome bezel at the 6 o'clock position and gently pry the prior to the engine starting, press the button again. button loose. 5