2012 Jeep Grand Cherokee Owner Manual - Page 91

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 89 gap panel. They are not visible until you fold the gap panel down. Do not use the cargo tie down hooks located on the floor behind the seat. Finally, tighten all three straps as you push the child restraint rearward and downward into the seat, removing slack in the straps according to the child restraint manufacturer's instructions. WARNING! Improper installation of a child restraint to the LATCH anchorages can lead to failure of an infant or child restraint. The child could be badly injured or killed. Follow the manufacturer's directions exactly when installing an infant or child restraint. secure a Child Restraint System (CRS). These types of seat belts are designed to keep the lap portion of the seat belt tight around the child restraint so that it is not necessary to use a locking clip. The ALR will make a ratcheting noise if you extract the entire belt from the retractor and then allow the belt to retract into the retractor. For additional information on ALR, refer to "Automatic Locking Mode" description under "Seat Belts in Passenger Seating Positions" section. The chart below defines the seating positions with an Automatic Locking Retractor (ALR). First Row Second Row Third Row Driver N/A ALR N/A Center N/A ALR N/A Passenger ALR ALR N/A 2 Installing Child Restraints Using The Vehicle Seat • N/A - Not Applicable Belts The seat belts in the passenger seating positions are • ALR - Automatic Locking Retractor equipped with an Automatic Locking Retractor (ALR) to