2010 Nissan Sentra Owner's Manual - Page 159
2010 Nissan Sentra Manual
Page 159 highlights
REARVIEW MONITOR (if so equipped) Beep tones: Select the "Beep Tones" key to toggle the beep tones feature on or off. When activated, a beep sound will be heard when a pop-up message appears on the screen or a button on the unit button) is pressed and held (such as the for two seconds. Reset all settings/memory: Select the "Reset All Settings/Memory" key to return all settings to default and to clear the memory. When the shift selector is shifted into the R (Reverse) position, the monitor display shows the view directly to the rear of the vehicle. ● Do not put anything on the rearview camera. The rearview camera is installed beside the license plate light. ● When washing the vehicle with highpressure water, be sure not to spray it around the camera. Otherwise, water may enter the camera unit causing water condensation on the lens, a malfunction, fire or an electric shock. ● Do not strike the camera. It is a precision instrument. Otherwise, it may malfunction or cause damage resulting in a fire or an electric shock. WARNING ● The system is designed as an aid to the driver in detecting large stationary objects to help avoid damaging the vehicle. The system will not detect small objects below the bumper, and may not detect objects close to the bumper or on the ground. ● The RearView Monitor is a convenience but it is not a substitute for proper backing. Always turn and check that it is safe to do so before backing up. Always back up slowly. ● Objects viewed in the RearView Monitor differ from actual distance because a wide-angle lens is used. ● Make sure that the trunk is securely closed when backing up. ● Underneath the bumper and the corner areas of the bumper cannot be viewed on the RearView Monitor because of its monitoring range limitation. Traffic setup Refer to the separate Navigation System Owner's Manual for information regarding this item. CAUTION There is a plastic cover over the camera. Do not scratch the cover when cleaning dirt or snow from the cover. BUTTON To change the display brightness, press the button. Pressing the button again will change the display to the day or the night display. If no operation is performed within 5 seconds, the display will return to the previous display. button for more than Press and hold the two seconds to turn the display off. Press the button again to turn the display on. 4-8 Display screen, heater, air conditioner, audio and phone systems