2010 Nissan Sentra Owner's Manual - Page 186

MUTE button: Press the button to mute the audio sound. To change the Speed Sensitive Volume (SSV) mode to OFF, LOW, MID or HIGH, press the or TUNE button setting is displayed. until the desired If no action is taken, the display will return to the regular clock display after 10 seconds. DISP (display) button This button works during FM, CD and iPod operation. See the detailed function for this button in the section for each mode. iPOD MENU, ENTER and BACK buttons These buttons can only be used for iPod operations. See "iPod Player Operation without Navigation System (Type A)" in this section for details about the functions of these buttons. Press the button again to resume playing the audio at its previous volume. AUDIO button (Bass, Treble, Fade, Balance, SSV, Beep): Press the AUDIO button to change the mode as follows: Bass → Treble → Fade → Balance → Speed Sensitive Volume (SSV) → Beep ON/OFF → Normal mode To adjust Bass, Treble, Fade and Balance, press the AUDIO button until the desired mode appears in the display. Press the TUNE or or SEEK or button to adjust the selected mode to the desired level. Fade adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers. To change the Beep to ON or OFF, press the TUNE button up or down until the desired mode is displayed. This will enable or disable the beep sound heard during menu selection. Once you have adjusted the sound quality to the desired level, press the AUDIO button repeatedly until the radio or CD display reappears. If no action is taken, the radio or CD display will automatically reappear after approximately 5 seconds. Clock set If the clock is not displayed with the ignition switch in the ACC or ON position, you need to select the CLK-ON mode. Press the MENU button repeatedly until CLK-OFF mode is displayed. Use the TUNE/FF-REW/FOLDER button to enable CLK-ON mode. 1. Press and hold the CLOCK button until the clock display starts to flash. 2. Press or 3. Press button the SEEK/TRACK button to adjust the hours. the or TUNE/FF-REW/FOLDER to adjust the minutes. FM/AM radio operation FM·AM button: Press the FM·AM button to change the band as follows: AM → FM1 → FM2 → AM If another audio source is playing when the FM·AM button is pressed, the audio source playing will automatically be turned off and the last radio station played will begin playing. The FM stereo indicator (ST) illuminates during FM stereo reception. When the stereo broadcast signal is weak, the radio automatically changes from stereo to monaural reception. 4. Press the CLOCK button again to exit the clock set mode. Display screen, heater, air conditioner, audio and phone systems 4-35