2010 Nissan Sentra Owner's Manual - Page 183

Press the SEEK or or TUNE or button to adjust the Bass, Treble, Fade and Balance to the desired level. Fade adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers. Once you have adjusted the sound quality to the desired level, press the MENU button repeatedly until the radio or CD display reappears. If no action is taken, the radio or CD display will automatically reappear after approximately 10 seconds. Clock set If the clock is not displayed with the ignition switch in the ACC or ON position, you need to select the CLK-ON mode. Press the MENU button repeatedly until CLK-OFF mode is displayed. Use the TUNE/FF-REW/FOLDER button to enable CLK-ON mode. 1. Press the MENU button repeatedly until "Clock:" appears. The hours will begin flashing. 2. Press the SEEK button or the TUNE button the hours. or or to adjust 4. Press the SEEK button or the TUNE button the minutes. or or to adjust SEEK tuning: or to tune Press the SEEK button from low to high or high to low frequencies and to stop at the next broadcasting station. SCAN tuning: Press the SCAN button to stop at each broadcasting station for 5 seconds. Pressing the button again during this 5 second period will stop SCAN tuning and the radio will remain tuned to that station. If the SCAN button is not pressed within 5 seconds, SCAN tuning moves to the next station. 1 to 6 Station memory operations: Twelve stations can be set for the FM band (6 for FM1, 6 for FM2) and six stations can be set for the AM band. 1. Choose the radio band AM, FM1 or FM2 using the AM·FM select button. 2. Tune to the desired station using manual, SEEK or SCAN tuning. Press and hold any of the desired station memory buttons (1 - 6) until a beep sound is heard. 3. The channel indicator will then come on and the sound will resume. Programming is now complete. 4. Other buttons can be set in the same manner. 5. Press the MENU button again to exit the clock set mode. If no action is taken, the display will return to the regular clock display after 10 seconds. FM/AM radio operation FM·AM button: Press the FM·AM button to change the band as follows: AM → FM1 → FM2 → AM If another audio source is playing when the FM·AM button is pressed, the audio source playing will automatically be turned off and the last radio station played will begin playing. The FM stereo indicator (ST) illuminates during FM stereo reception. When the stereo broadcast signal is weak, the radio automatically changes from stereo to monaural reception. TUNE button (Tuning): Press the TUNE button manual tuning. or for 3. Press the MENU button again. The minutes will begin flashing. 4-32 Display screen, heater, air conditioner, audio and phone systems