1996 Pontiac Firebird Owner's Manual - Page 295

Using Foam-Qpe Cleaner on Fabric 1. Vacuum andbrush the area to remove any loose d.ilt Using Solvent-'Qpe Cleaner on Fabric First, seeif you have to use solvent-typecleaner at all. off Some spots and stains will clean better withjust water and mild soap. 2. Always clean a whole trim panel or section. Mask surrounding trim along stitch welt lines. or 3. Mix Muhi-Purpose Powdered Cleaner following the directions on the container label. 4. Use suds onlyand apply with a clean sponge. 5. Don't saturate the material. 6. Don't rub it roughly. a 7. As soon as you've cleaned the section, use sponge to remove the suds. a. -Rinse the section with a clean, wet sponge. 9. Wipe off what's left witha slightly damp paper If you need.to use a solvent: Gently scrape excess soil from the trim materialwt ih a clean, dull knife or scraper. Use very little cleaner, light pressure and clean cloths (preferab'ly the cheesecloth). Cleaning should start at outside of the stain, "feathering" toward the center. Keep changing to a clean sectionof the cloth. When you clean a stain from fabric, im.mediately dry the area with a blow dryer to help prevent a cleaning ring. or towel \ 10. Then dry it immediately witha blow dryer. 11. Wipe with a clean cloth. 6-54