AIWA NSX-V2100 Operating Instructions - Page 17

Troubleshooting, Guide, Parts Index

Page 17 highlights

TROUBLESHOOTING GUIDE PARTS INDEX If the unit fails to perform as described in these Operating Instructions, check the following guide. GENERAL There is no sound. q Is the AC cord connected properly? q Is there a bad connection? (+ page 3) q There may be a short circuit in the speaker terminals. + Disconnect the AC cord, then correct the speaker connections. q Was an Incorrect function button pressed? Sound is emitted from one speaker only. q IS the other speaker disconnected? An erroneous display or a malfunction occurs. + Reset the unit as stated below. TUNER SECTION There is constant, wave-like static. q Is the antenna connected properly? (+ page 3) + Change the orientation of the antenna. The reception contains noise interferences or the sound is distorted. q Is the system picking up external noise or muitipath distortion? + Change the orientation of the antenna. + Move the unit away from other electrical appliances. CASSETTE DECK SECTiON The tape does not run. q is a deck in pause mode? (+ page 9) The sound is off-baiance or not adequately high. q is the playback head dirty? (+ page 15) Recording is not possible. q Is the erasure prevention tab on the tape broken off? (+ page 12) q Is the recording head dirty? (~ page 15) Erasure is not possible. q Is the erasure head dirty? (+ page 15) q Is a metal tape being used? High frequency sound is not emitted. q is the recording/piayback head dirty? (+ page 15) CD PLAYER SECTiON The CD Iplayer does not piay. q is the disc correctiy inserted? (A page 7) q is the disc dirty? (+ page 15) q Is the iens affected by condensation? + Wait approximateiy one hour and try again. To reset if an unusual condition occurs in the display window or the cassette decks, reset the unit as follows. 1 Press the POWER button to turn off the power. 2 Press the POWER button while pressing the s CLEAR button. Everything stored in memory after purchase is canceled. If the pclwer cannot be turned off in step 1 because of a malfunctim, reset by disconnecting the AC cord and repeat step Instructions about each ~art on the main unit or remote control are indicated on the pages listed below. (in alphabetical order) Parts CD s CLEAR GRAPHIC EGWALiZER (ROCK/POP/JAZZ) DISC CHANGE DiSC DiRECT PLAY (1, 2, 3) = OpEN/CLOSE PHONES POWER - PRESET 11 SET TAPE T-BASS TUNER/BAND

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52

TROUBLESHOOTING
GUIDE
If the unit fails
to perform
as described
in these
Operating
Instructions,
check the following
guide.
GENERAL
There
is
no
sound.
Is the AC cord connected
properly?
Is there a bad connection?
(+
page 3)
There may be a short circuit in the speaker terminals.
+
Disconnect
the
AC
cord,
then
correct
the
speaker
connections.
Was an
Incorrect
function
button pressed?
Sound
is emitted
from one speaker
only.
IS
the other speaker disconnected?
An erroneous display or a malfunction
occurs.
+
Reset the unit as stated below.
TUNER
SECTION
There
is constant,
wave-like
static.
Is the antenna connected
properly?
(+
page 3)
+
Change the orientation
of the antenna.
The reception
contains
noise interferences
or the sound
is distorted.
Is
the system picking up external noise or muitipath distortion?
+
Change the orientation
of the antenna.
+
Move the unit away from other electrical appliances.
CASSETTE DECK SECTiON
The tape does not run.
is a deck in pause mode? (+
page 9)
The sound
is off-baiance
or not adequately
high.
is the playback head dirty? (+
page 15)
Recording
is not possible.
Is the erasure prevention
tab on the tape broken off? (+ page
12)
Is the recording head dirty? (~
page 15)
Erasure
is
not possible.
Is the erasure head dirty? (+
page 15)
Is a metal tape being used?
High frequency
sound
is not emitted.
is the recording/piayback
head dirty? (+
page 15)
CD PLAYER SECTiON
The CD Iplayer does not piay.
is the disc correctiy inserted?
(A page 7)
is the disc dirty? (+
page 15)
Is the iens affected by condensation?
+
Wait approximateiy
one hour and try again.
To reset
if an unusual
condition
occurs
in the display
window
or the
cassette decks, reset the unit as follows.
1
Press the POWER button to turn off the power.
2
Press the POWER button while pressing the
CLEAR button.
Everything stored in memory after purchase is canceled.
If the
pclwer cannot
be turned
off in step
1 because
of a
malfunctim,
reset by disconnecting the AC cord and repeat step
PARTS INDEX
Instructions
about each ~art on the main unit or remote control
are indicated on the pages listed below.
(in alphabetical
order)
Parts
CD
CLEAR
4, 7
6, 7
GRAPHIC EGWALiZER (ROCK/POP/JAZZ)
5
DISC CHANGE
7
DiSC DiRECT PLAY (1, 2, 3)
7, 10, 11
= OpEN/CLOSE
7
PHONES
5
POWER
4
-
PRESET
6,7
11 SET
4, 6, 7
TAPE
4, 9
T-BASS
5
TUNER/BAND
4, 6
<4,
-
TUNiNG
(1<< DOWN/W>l
UP)
4,6,7
ViDEO/AUX
4,
14
VOLUME
5
D
w
Deck 1,2 operation
buttons
9,10,11
BAND (+1O)
6
CLEAR
6, 7
CLOCK (9)
4
DiSC DiRECT PLAY (1, 2, 3)
7, 10, 11
EDiT/CHECK
(1)
7, 10, 11
FUNCTION
4
GEQ (4)
5
MONO/TUNER
(0)
6
-
PRESET
6, 7
PRGM (2)
8
RANDOM/REPEAT
(3)
8
11 SET
4, 6, 7
SHiFT
4
SLEEP (8)
12
T-BASS (6)
5
TiMER
(7)
13
+<,
P
TUNING
(i<<
DOWN/*>1
UP)
4,6,7
VOLUME
(A,
V)
5
0-9, +10
6,7,
10, 11
ENGLISH16