Bernina 730 Manual - Page 16

Inserting the bobbin into the case and threading the under thread Replacing bobbin case with bobbin into shuttle When replacing bobbin into case, make sure that bobbin turns in direction of arrow when thread is pulled (see fig. 9). After insertion ob bobbin pass thread through slot 27, below tension spring 28, and allow it to come out at the end of tension spring 29. recess in the shuttle race cover. Then place the bobbin case on the shuttle pin until it strikes the bottom. Now release latch and make sure that it is properly closed. Fig. 9 Insertion of bobbin case is possible only when the needle is in its uppermost position. The bobbin case is held by the opened latch 33, same as when removing it (fig. 6). Thumb and forefinger of the left hand hold the hinged latch so that the bobbin case finger 30 (fig. 9) points upward and can enter the 14 Long groove po. facing you I Fig. 10