Bernina 730 Manual - Page 26
Darning
View all Bernina 730 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Darning When the machine is set for darning and mending, proceed as follows : 1. Raise thread take-up lever. 2. Remove presser foot and insert darning or hopper foot. 3. Lower feed dog by turning knob 23 to the left upon " darning" symbol (see page 16). 4. Set stitch regulator lever 22 upon zero point to prevent the feed dog from being operated unnecessarily. 5. Adjust zigzag knob 18 upon zero position. The ItERNINA-Record, Models 730, 731 and 732, can be used for darning with or without the slide-on table, depending on the kind of material to be darned. Darning table linen, towels a.s.o. Cut out the whole damaged spot, so that only solid material remains. Start as shown in fig. 24 a, in directing the work by hand, so that one thread comes to lie directly along the other. It will be useful to guide the threads about 13/64" beyond the edge of the hole, but in somewhat different lengths altogether. This will strengthen the material round the hole, without giving a heavy darn. 24 a • 6, •