Brother International BAS-342G Instruction Manual - English - Page 26
Lubrication [13], Lube 10N; VG10> specified by Brother.
View all Brother International BAS-342G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
4. INSTALLATION 4-18. Lubrication [13] CAUTION Do not connect the power cord until lubrication is complete. If the foot switch is depressed by mistake, the sewing machine might start operating and injury could result. Be sure to wear protective goggles and gloves when handling the lubricating oil and grease, so that they do not get into your eyes or onto your skin. If the oil and grease get into your eyes or onto your skin, inflammation can result. Furthermore, do not drink or eat the lubricating oil or grease. They may cause diarrhea or vomiting. Keep the oil out of the reach of children. • The sewing machine should always be lubricated and the oil supply replenished before it is used for the first time, and also after long periods of non-use. • Use only the lubricating oil specified by Brother. * If this type of lubricating oil is difficult to obtain, the recommended oil to use is 1. Fill the arm oil tank and the bed oil tank with oil. NOTE: Be sure to add more oil when the oil level drops down to about one-third full in the oil gauge window (1). If the oil drops below the one-third full level in the oil gauge window (1), there is the danger that the sewing machine may seize during operation. 3984M 3985M 3986M 17 2. Pour oil in through the two holes (2) of the shuttle race base assembly so that the felt is lightly moistened. NOTE: If there is no more oil on the felt of the shuttle race base assembly, problems with sewing may result. 3. If using the needle cooler (3), fill it with silicon oil (100 mm2/s). (Refer to "5-3. Threading the upper thread" for details on using the needle cooler (3).) BAS-342G