Brother International CB3-B917 Service Manual - Page 23
Brake] P.39.
View all Brother International CB3-B917 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
3. ASSEMBLY AND ADJUSTMENT 3-2. Number of stitches changing Mark 308s 309s 1. Fit the clutch to the clutch shaft the set screw . and secure with 2. Rotate the stop cam (pulley) and align the marking on the vertical feed cam with the cam positioning pin . Apply grease 3. Fit the number of stitches adjustment M-gear , snap ring to the adjustment M-gear shaft . 4. Fit the number of stitches adjustment cam to the cam shaft . 5. Attach the thread trimmer lever to the clutch shaft . 310s 6. Insert the brake shaft into the hole in the bed. 7. Insert the brake lever shaft into the oval hole in the brake lever , and provisionally tighten the set screw on the bottom side of the clutch body . 8. Turn the brake shaft until the screw is facing upward, and then secure it by tightening the set screw . * Adjust the brake while referring to section Adjustment of [Brake] (P.39). 9. Contact the stop cam side to the clutch. 311s Contact 334s 17 CB3-B916A/B917A