Brother International Innov-is 4750D Operation Manual - Page 159

c Insert the embroidery unit connection into the machine connection port. Push lightly until the unit clicks into place. BEFORE EMBROIDERING Note • A confirmation message to lower the frame- securing lever after the carriage moves to its initial position. b ca a Embroidery unit connection b Machine connection port • The message will disappear after 15 sec- c Feed dog position switch onds or press to move to the next Note • Be sure there is no gap between the embroi- dery unit and the sewing machine. If there is a gap, the embroidery patterns will not embroider with the correct registration. • Do not push on the carriage when installing the embroidery unit onto the machine. Moving the carriage may damage the embroidery unit. step. ■ Removing the Embroidery Unit a Press either or , then press . • Be sure to set the feed dog position switch to right to lower the feed dogs. → The carriage will move to the removal position. 5 Embroidery d Turn the main power to ON. → The following message will appear. e Press . CAUTION • Always remove the embroidery frame before pressing . Otherwise, the frame may strike the embroidery foot, and possibly cause injury. • The embroidery unit will not fit in the storage case if this step is not done. b Turn the main power to OFF. → The carriage will move to the initialization position. Note • Be sure to turn off the machine before attaching the embroidery unit, otherwise damage to the machine may result. 147