Brother International Innov-is 4750D Operation Manual - Page 188

MAKING EMBROIDERY ADJUSTMENTS b Press TRIM. to turn off JUMP STITCH Adjusting the Embroidery Speed a Press and Embroidery. → The key will display as * The machine will not trim the thread before moving to the next stitching. ■ Selecting the length of JUMP STITCH not to trim When the thread trimming function is turned on, you can select the length of the jump stitch not to trim the thread. This function can be turned on or off during embroidering. Select a setting from 5 mm to 50 mm in 5 mm increments. * Your customized setting remains after turning off and on the machine. Press or to select the length of JUMP STITCH. For example: Press to select 25 mm (1 inch) and the machine will not trim a jump stitch of 25 mm or less before moving to the next stitching. Note • If design has many trims it is recommended to select a higher jump stitch trim setting in order to reduce the amount of excess tails on backside of fabric. • The higher number of the jump stitch length selected, the fewer number of times the machine will trim. In this case, more jump stitches remain on the surface of the fabric. b In the MAX EMBROIDERY SPEED display, use to change the maximum embroidery speed. * You can choose from 3 different speed levels. Memo • SPM is the number of stitches sewn in one minute. • Decrease the sewing speed when embroidering on thin, thick, or heavy fabrics. • The sewing speed can be changed while embroidery is being sewn. • The maximum sewing speed setting does not change until a new setting is selected. The setting specified before the main power is set to OFF remains selected the next time that the machine is turned on. • Decrease the sewing speed to 600 spm when using a speciality thread like a metallic thread. c Press . 176