Brother International Innov-is 4750D Operation Manual - Page 80
Gathering
View all Brother International Innov-is 4750D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
SEWING THE STITCHES e Iron the dart to one side so that it is flat. d Sew two rows the seam line, of straight stitches parallel then trim excess thread to leaving 50 mm (approx. 1-15/16 inches). b a c Gathering Use on waists of skirts, sleeves of shirts, etc. a Select a straight foot "J". stitch and attach presser a Seam line b 10 to 15 mm (approx. 3/8 inch to 9/16 inch) c About 50 mm (approx. 1-15/16 inches) e Pull the bobbin threads to obtain the desired amount of gather, then tie the threads. f Smooth the gathers by ironing them. b Set the stitch length to 4.0 mm (approx. 3/16 inch) and the thread tension to approximately 2.0 (weaker tension). * If you press after pressing , the stitch length will be set automatically to 4.0 mm (approx. 3/16 inch) and the thread tension will be automatically set to 2.0. c Pull the bobbin and upper threads out by 50 mm (approx. 1-15/16 inches) (see page 28). g Sew on basting the seam stitch. line and remove the a b c a Upper thread b Bobbin thread c About 50 mm (approx. 1-15/16 inches) 68