Brother International Innov-is 4750D Operation Manual - Page 89

d Position the cutter pin is side cutter so that the side aligned with the notch in the presser foot holder, and then lower the presser foot. SEWING THE STITCHES g Thread the needle manually and pull out long section of the upper thread. Pass it a below the presser foot and pull it out in the fabric feed direction. ba b a a Notch in presser foot holder b Pin a Presser foot → The side cutter is attached. b Upper thread e Make a cut of approximately 20 (approx. 3/4 inch) in the fabric. mm h Start sewing. 3 a Utility Stitches a 20 mm (approx. 3/4 inch) f Position the fabric so that the right side of the cut is on top of the guide plate and the left side of the cut is underneath the presser foot. a b a Guide plate (lower knife) b Presser foot Memo If the fabric is not positioned correctly, the fabric will not be cut. → A seam allowance is cut while the stitching is sewn. Note If the width has been adjusted, turn the handwheel by hand to check that the needle does not touch the side cutter. If the needle touches the side cutter, it might cause the needle to break. 77