Canon imagePROGRAF iPF6300S iPF6300S User Manual ver.1.00 - Page 1039

3. Press the OK button. Troubleshooting > Problems Regarding Paper > Roll paper cannot be inserted into the paper feed slot Cause The roll paper is warped. Paper is jammed by the paper feed slot. After a roll was advanced, the paper was manually pulled out by force, closing the Paper Feed Slot. Corrective Action Straighten out curls and reload the roll. Remove the jammed paper. (See "Clearing Jammed Roll Paper.") →P.1014 (See "Clearing a Jammed Sheet, Fed Manually.") →P.1018 Remove the roll and open the paper feed slot. (See "Removing the Roll from the Printer.") →P.790 Cannot load sheets Cause Corrective Action The paper source selection is incorrect. Press the Load button and select the paper source. Paper is not cut neatly Cause The paper is bent or curled at the cut position. Paper rises by the ends of the cut position before it is cut. You are using paper that cannot be cut with the Cutter Unit. Cut Speed is not configured correctly in the Control Panel menu. During cutting, printed documents fall out at an angle. Corrective Action Straighten out any curling by the edges of the paper. Reload the paper correctly. Specify Manual in Cutting Mode in the Control Panel menu and use scissors or a cutting tool to cut the roll after printing. (See "Specifying the Cutting Method for Rolls.") →P.797 Change the Cut Speed setting in the Control Panel menu. (See "Menu Structure.") →P.904 In the Control Panel menu, set Cutting Mode to Eject. Hold documents after printing, as they are cut. (See "Specifying the Cutting Method for Rolls.") →P.797 12 1021 iPF6300S Roll paper cannot be inserted into the paper feed slot