Canon imagePROGRAF iPF650 iPF650 655 750 755 Basic Guide Step1 - Page 3

Safety Precautions Caution █ Printer location • Never install the printer on an unstable or vibrating surface. If it falls over, this could cause personal injury. • Never set up the printer in a location that is exposed to high humidity or large amounts of dust, or exposed to direct sunlight, high temperature, or open flame. This could cause a fire or electrical shock. Use the printer location in an environment where temperature and humidity are within the ranges of 15°C to 30°C (59°F to 86°F) and 10 to 80% RH (with no condensation). • Never place the printer on a heavy wool or shag carpet. The fibers may enter the printer and cause a fire. • Keep the area around the power outlet clear of items so that you can disconnect the power cable immediately if the printer starts operating abnormally. In the event of a printer malfunction, remove the power cable from the outlet as soon as possible to prevent fire and electrical shocks. • Do not install the printer near sources of strong electromagnetic fields, whether equipment that generates such fields or places where such fields occur. This could damage the printer or cause malfunction. █ Moving the Printer • The weights of main printer units are as follows: iPF750 or iPF755: approx. 52 kg (115 lb) iPF650 or iPF655: approx. 43 kg (95 lb) • Moving the printer requires at least three people, holding it on both sides and from behind. Be careful to avoid back strain and other injuries. • When moving the printer, firmly grasp the Carrying Handles under each side and in back. Holding the printer at other positions is dangerous and poses a risk of injury and damage if the printer is dropped. █ Power Supply • Always grip the plug to remove the power cable from the power outlet. Pulling on the power cable could damage the cable and lead to a fire or electrical shock. • Never use an extension cord. This could cause a fire or electrical shock. • Never use any power source other than 100-120 / 220-240 V AC. This could cause a fire or electrical shock. The printer operating conditions are described below. Use the printer under the following conditions. Power supply voltage: 100-120 / 220-240 V AC Power supply frequency: 50/60Hz █ Cleaning the Printer • Always disconnect the power cable from the outlet before cleaning the printer. If the printer is switched on accidentally, moving parts inside the printer may cause personal injuries. █ Printhead, Ink Tanks, and Maintenance Cartridge • Always store consumables in a safe location out of the reach of small children. If a child licks or ingests ink accidentally, seek medical assistance immediately. • If ink accidentally gets in your eyes, immediately rinse with water. If ink gets on your skin, immediately clean it off with soap and water. If irritation persists in your eyes or on your skin, contact a physician immediately. • Avoid dropping or shaking printheads, ink tanks, and maintenance cartridges. Spilled ink can stain clothing and the work area. • Never touch the electrical contacts of the Printhead after printing. The contacts become extremely hot and can cause minor burns. 3