Cisco CP-7911G-CH1 Administration Guide - Page 141

Configuring Call Handling How to Configure Cisco Unified SCCP SRST In the configuration below, the voice translation-rule and the rule command allow you to set and define how a number is to be manipulated. The translate command in voice translation-profile mode defines the type of number you are going to manipulate, such as a called, calling, or a redirecting number. Once you have defined your translation profiles, you can then apply the translation profiles in various places, such as dial peers and voice ports. For SRST, you apply your profiles in call-manager fallback mode. Cisco IP phones support one incoming and one outgoing translation profile when in SRST mode. Note For Cisco SRST 3.2 and later versions and Cisco Unified SRST 4.0 and later versions, use the voice translation-rule and translation-profile commands shown below instead of the translation rule configuration described in the "Enabling Digit Translation Rules" section on page 139. Voice translation rules are a separate feature from translation rules. See the voice translation-rule command in Cisco IOS Voice Command Reference for more information and the VoIP Gateway Trunk and Carrier Based Routing Enhancements documentation for more general information on translation rules and profiles. SUMMARY STEPS 1. voice translation-rule number 2. rule precedence/match-pattern/ /replace-pattern/ 3. exit 4. voice translation-profile name 5. translate {called | calling | redirect-called} voice-translation-rule-tag 6. exit 7. call-manager-fallback 8. translation-profile {incoming | outgoing} name 9. exit OL-13143-04 Cisco Unified SCCP and SIP SRST System Administrator Guide 141