Cisco CP-7911G-CH1 Administration Guide - Page 25

Cisco Unified SCCP and SIP SRST Feature Overview Where to Go Next Signal Support Cisco Unified SRST supports FXS, FXO, T1, E1, and E1 R2 signals. Language Support See Cisco Unified Communications Manager Express Cisco Unified CME Localization Matrix. Switch Support Cisco SRST 3.2 and later versions support all PRI and BRI switches including the following: • basic-1tr6 • basic-5ess • basic-dms100 • basic-net3 • basic-ni • basic-ntt NTT switch type for Japan • basic-ts013 • primary-4ess Lucent 4ESS switch type for the United States • primary-5ess Lucent 5ESS switch type for the United States • primary-dms100 Northern Telecom DMS-100 switch type for the United States • primary-net5 NET5 switch type for the United Kingdom, Europe, Asia, and Australia • primary-ni National ISDN switch type for the United States • primary-ntt NTT switch type for Japan • primary-qsig QSIG switch type • primary-ts014 TS014 switch type for Australia (obsolete) Where to Go Next The next chapters of this book describe how to configure Cisco Unified SIP SRST. As shown in Table 3, each chapter takes you through tasks in the order in which they need to be performed. The first task for configuring Cisco Unified SRST is to ensure that the basic software and hardware in your system are configured correctly for Cisco Unified SRST. Table 3 Cisco Unified SRST Configuration Sequence Task Where Task Is Described 1. Setting up a Cisco Unified SRST system Setting Up the Network, page 63 to communicate with your network 2. Configuring Version 4.1 features Cisco Unified SIP SRST 4.1, page 75 3. Setting up the basic Cisco Unified SRST Setting Up Cisco Unified IP Phones using SCCP, phone configuration using SCCP page 85 OL-13143-04 Cisco Unified SCCP and SIP SRST System Administrator Guide 25