Cisco CP-7911G-CH1 Administration Guide - Page 88

How to Set Up Cisco Unified IP Phones Setting Up Cisco Unified IP Phones using SCCP Step 5 Command or Action limit-dn phone-type max-lines Example: Router(config-cm-fallback)# limit-dn 7945 2 Step 6 exit Example: Router(config-cm-fallback)# exit Purpose (Optional) Limits the directory number lines on Cisco IP phones during Cisco Unified CM fallback. Note You must configure this command during initial Cisco Unified SRST router configuration, before any phone actually registers with the Cisco Unified SRST router. However, you can modify the number of lines at a later time.  For a list of available phones, see Cisco SRST and SIP SRST Command Reference (All Versions). The setting for maximum lines is from 1 to 6. The default number of maximum directory lines is set to 6. If there is any active phone with the last line number greater than this limit, warning information is displayed for phone reset. Exits call-manager-fallback configuration mode. Configuring Cisco Unified 8941 and 8945 SCCP IP Phones To configure Cisco Unified 8941 and 8945 SCCP IP Phones in SRST mode, perform the following commands: Note This section is required only in SRST version 8.6 and is not required for version 8.6 and higher. SUMMARY STEPS 1. enable 2. configure terminal 3. ephone-type phone-type 4. device-id number 5. device-type phone-type 6. end Cisco Unified SCCP and SIP SRST System Administrator Guide 88 OL-13143-04