Cisco CP-7911G-CH1 Administration Guide - Page 66

How to Set Up the Network Setting Up the Network Step 4 Command or Action call application alternate [application-name] or service [alternate | default] service-name location Example: Router(config)# call application alternate or Router(config)# service default Step 5 exit Example: Router(config)# exit Purpose The call application alternate command specifies that the default voice application takes over if the MGCP application is not available. The application-name argument is optional and indicates the name of the specific voice application to use if the application in the dial peer fails. If a specific application name is not entered, the gateway uses the DEFAULT application. Or The service command loads and configures a specific, standalone application on a dial peer. The keywords and arguments are as follows: • alternate (Optional). Alternate service to use if the service that is configured on the dial peer fails. • default (Optional). Specifies that the default service ("DEFAULT") on the dial peer is used if the alternate service fails. • service-name: Name that identifies the voice application. • location: Directory and filename of the Tcl script or VoiceXML document in URL format. For example, flash memory (flash:filename), a TFTP (tftp://../filename), or an HTTP server (http://../filename) are valid locations. Exits global configuration mode and returns to privileged EXEC mode. Configuring SRST on an MGCP Gateway Using Cisco IOS Release 12.3(14)T or Later Releases Perform this task to enable SRST on an MGCP Gateway if you are using Cisco IOS Release 12.3(14)T or later version. Restrictions Effective with Cisco IOS Release 12.3(14)T, the call application alternate command is replaced by the service command. The service command can be used in all releases after Cisco IOS Release 12.3(14)T. Cisco Unified SCCP and SIP SRST System Administrator Guide 66 OL-13143-04