Cisco CP-7911G-CH1 Administration Guide - Page 151

Configuring Call Handling How to Configure Cisco Unified SCCP SRST Step 6 Command or Action voice service voip Purpose (Optional) Enters voice service configuration mode. Step 7 Example: Router(config)# voice service voip h323 (Optional) Enters H.323 voice service configuration mode. Step 8 Step 9 Example: Router(conf-voi-serv)# h323 h450 h450-2 timeout {T1 | T2 | T3 | T4} milliseconds Example: Router(conf-serv-h323)# h450 h450-2 timeout T1 750 end (Optional) Sets timeouts for supplementary service timers, in milliseconds. This command is used primarily when the default settings for these timers do not match your network delay parameters. See the ITU-T H.450.2 specification for more information on these timers. • T1: Timeout value to wait to identify a response. Default is 2000. • T2: Timeout value to wait for call setup.  Default is 5000. • T3: Timeout value to wait to initiate a response. Default is 5000. • T4: Timeout value to wait for setup of a response. Default is 5000. • milliseconds: Number of milliseconds.  Range is from 500 to 60000. (Optional) Returns to privileged EXEC mode. Example: Router(conf-serv-h323)# end Examples The following example specifies transfer with consultation using the H.450.2 standard for all IP phones serviced by the Cisco Unified SRST router: dial-peer voice 100 pots destination-pattern 9.T port 1/0/0 dial-peer voice 4000 voip destination-pattern 4... session-target ipv4:10.1.1.1 call-manager-fallback transfer-pattern 4... transfer-system full-consult The following example enables call forwarding using the H.450.3 standard: dial-peer voice 100 pots destination-pattern 9.T port 1/0/0 ! OL-13143-04 Cisco Unified SCCP and SIP SRST System Administrator Guide 151