Compaq ProLiant 6500 Compaq Parallel Database Cluster Model PDC/05000 for Orac - Page 121

Installation and Configuration 5-25 set this_controller port_2_topology=loop_hard set other_controller port_2_topology=loop_hard IMPORTANT: The ALPA addresses of port 1 on both array controllers must be identical; the ALPA addresses of port 2 on both array controllers must be identical. Use only the specified hexadecimal numerals for the ALPA addresses. For the array controllers, first use the middle-range ALPA addresses. When middle range ALPA addresses are no longer available, use the higher-range ALPA addresses. If neither is available, use the lower-range ALPA addresses. Make sure that you do not use an ALPA address recommended for the KGPSA-BC Host adapter in the "Installing the FCSS Utility" section of this chapter. Lower-range ALPA addresses have a higher priority than middle range addresses. The middle-range ALPA addresses that you can use are: 4A, 4B, 4C, 4D, 4E, 51, 52, 53, 54, 55, 56, 59, 5A, 5C, 63, 65, 66, 67, 69, 6A, 6B, 6C, 6D, 6E, 71, 72, 73, 74, 75, 76, 79, 7A, 7C, 80, 81, 82, 84, 88, 8F, 90, 97, 98, 9B, 9D, 9E, 9F, A3, A5, A6, A7, A9, AA, AB, AC The higher-range ALPA addresses that you can use are: AD, AE, B1, B2, B3, B4, B5, B6, B9, BA, BC, C3, C5, C6, C7, C9, CA, CB, CC, CD, CE, D1, D2, D3, D4, D5, D6, D9, DA, DC, E0, E1, E2, E4, E8, EF The lower-range ALPA addresses that you can use are: 01, 02, 04, 08, 0F, 10, 17, 18, 1B, 1D, 1E, 1F, 23, 25, 26, 27, 29, 2A, 2B, 2C, 2D, 2E, 31, 32, 33, 34, 35, 36, 39, 3A, 3C, 43, 45, 46, 47, 49 14. Restart the array controllers. a. If you have a separate CLI window open for each controller, type the following in both CLI windows and press Enter: restart this_controller b. If there is one CLI window open for both controllers, type the following and press Enter: restart other_controller restart this_controller 15. Wait a few minutes for the array controllers to restart. 16. Type the following in the top controller CLI window and press Enter: show this_controller