Compaq ProLiant 6500 Compaq Parallel Database Cluster Model PDC/05000 for Orac - Page 128

5-32 Compaq Parallel Database Cluster Model PDC/O5000 for Oracle8i and Windows 2000 Administrator Guide 11. If not, type the following and press Enter for other units (virtual disks) as necessary: set unit-number enable_access_path=ALL Example: Set D1 enable_access_path=ALL 12. Close the CLI window. 13. Restart all nodes in the cluster. NOTE: To complete storageset configuration, you must create partitions on the virtual disks using Disk Management. While you can perform this step now, it is recommended you do it after completing Secure Path software installation. If you create partitions now, Disk Management will show double images of all virtual disks, which can be confusing. If you create partitions after installing Secure Path software, Disk Management shows the correct number of virtual disks. Installing Secure Path Software for Windows 2000 If you have installed more than one MA8000/EMA12000 Storage Subsystem in your PDC/O5000: I For the first storage subsystem in the PDC/O5000, perform all of the steps listed in this section. The steps in "Installing the Secure Path Drivers, Secure Path Agent, and Secure Path Manager" are performed only for the first storage subsystem. I For every other storage subsystem in the PDC/O5000, repeat all of the steps in this section except those in "Installing the Secure Path Drivers, Secure Path Agent, and Secure Path Manager." Overview of Secure Path Software Installation The following subsections give an overview of the software configuration procedures required for your Secure Path storage environment. For detailed procedures, refer to the Compaq StorageWorks Secure Path for Windows 2000 on RAID Array 4000/4100 Version 3.1. I Install the host adapter drivers I Install the Fibre Channel Software Setup (FCSS) utility