Compaq ProLiant 6500 Compaq Parallel Database Cluster Model PDC/05000 for Orac - Page 179
Preparing the New Node, Install and con Windows 2000 Advanced Server
View all Compaq ProLiant 6500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 179 highlights
Cluster Management 6-25 This can be a time-consuming and complex procedure. Be sure to read through all of the following directions as well as those in the Oracle documentation before starting. Adding a new node involves the following activities: I Preparing the new node I Preparing the existing cluster nodes I Installing the cluster software These subsections contain a high-level outline of the steps to follow. If you need detailed instructions you should read Chapter 5, "Installation and Configuration." Preparing the New Node To minimize downtime of the cluster, several preparation steps should be performed on the new node before it is integrated into the cluster. Prior to integrating the new node into the cluster, perform the following steps: 1. Connect the server for the new node to the cluster interconnect and to the client LAN. Power on the new node. Although physically connected to the cluster, the server is not yet integrated into the cluster. IMPORTANT: Do not connect the server to the Storage Hubs or Fibre Channel SAN Switches yet. 2. Start the new node with the Compaq SmartStart and Support Software CD in the CD-ROM drive. 3. Use the Compaq System Configuration Utility to configure the hardware settings of the node and its adapters. 4. Use the Compaq Array Configuration Utility to configure the node's local non-shared disks with RAID. 5. Install and configure Windows 2000 Advanced Server with Service Pack 1 or later (whichever is installed on the other nodes). 6. Install necessary Compaq drivers and utilities from the Compaq SmartStart and Support Software CD. 7. Enter unique IP addresses and node names for each node in the hosts and lmhosts files located at %SystemRoot%\system32\drivers\etc.