D-Link DSN-3400-10 User's Manual for DSN-3200-10 Valid for firmware 1.6.1 - Page 38

4.2 Entering Initial Management Port Settings After you click the Next button in the Welcome screen, the Management Port screen in Figure 4-2 appears. This screen lets you specify the settings that client computers will use to access the xStack Storage Array management console. The values you enter must be compatible with your local network and accessible to the client computers that will be accessing the xStack Storage Array management console. Complete the fields on this screen (see Table 4-1), then click the Next button when finished. If you need to change these initial settings at a later time, use the procedures described in Chapter 5. Setting IP Address Subnet Default Gateway Host name Figure 4-2 Management Port Screen Table 4-1. Initial Management Port Settings Description Enter the IP address that client computers must use to access the xStack Storage Array's management console. Make note of the new IP address for reference purposes. Enter the subnet mask that client computers must use to access the xStack Storage Array's management console. The NIC in the management PC will be modified to use the same subnet when you finish the OOBE setup wizard. Enter the default gateway that client computers must use to access the xStack Storage Array's management console. The xStack Storage Array is assigned a default host name. If desired, you can change this name to one that is meaningful to you. 38 Chapter 4 Starting the xStack Storage Array for the First Time