Dell Alienware m17 R3 Service Manual - Page 14
Solid state drive—M.2 slot one, Removing the 2280 solid-state drive from the M.2 slot one
View all Dell Alienware m17 R3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Steps 1. Connect the battery cable to the system board, if applicable. 2. Slide the notches on the top of the base cover under the rear I/O-cover and snap the base cover into place on the palm-rest assembly. 3. Tighten the six captive screws on the base cover. 4. Replace the two screws (M2.5x9) that secure the base cover to the palm-rest assembly. Next steps 1. Follow the procedure in After working inside your computer. Solid state drive-M.2 slot one Removing the 2280 solid-state drive from the M.2 slot one Prerequisites 1. Follow the procedure in Before working inside your computer. 2. Remove the base cover. About this task NOTE: This procedure applies only to computers shipped with a 2280 solid-state drive installed in M.2 slot one. NOTE: Depending on the configuration ordered, your computer may support either 2230 solid-state drive or 2280 solidstate drive in M.2 slot one. 14