Dell Alienware m17 R3 Service Manual - Page 51
Fan and heat-sink assembly, Removing the fan and heat-sink assembly
View all Dell Alienware m17 R3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Steps 1. Using the alignment pins, place the interposer board on the system board. 2. Using the alignment pins, connect the left I/O-board to the system board through the interposer board. 3. Align the screw holes on the left I/O-board with the screw holes on the system board and interposer board. 4. Replace the four screws (M2x4.5) that secure the left I/O-board to the system board. Next steps 1. Follow step 3 to step 22 in installing the system board. 2. Install the battery. 3. Install the rear I/O-cover. 4. Install the 2280 solid-state drive in M.2 slot two, if installed. 5. Install the 2230 solid-state drive in M.2 slot two, if installed. 6. Install the 2280 solid-state drive in M.2 slot one, if installed. 7. Install the 2230 solid-state drive in M.2 slot one, if installed. 8. Install the base cover. 9. Follow the procedure in After working inside your computer. Fan and heat-sink assembly Removing the fan and heat-sink assembly Prerequisites 1. Follow the procedure in Before working inside your computer. 2. Remove the base cover. 3. Remove the 2230 solid-state drive in M.2 slot one, if installed. 4. Remove the 2280 solid-state drive in M.2 slot one, if installed. 5. Remove the 2230 solid-state drive in M.2 slot two, if installed. 6. Remove the 2280 solid-state drive in M.2 slot two, if installed. 7. Remove the rear I/O-cover. 8. Remove the battery. 9. Follow step 1 to step 21 in removing the system board. 51