Dell Dimension 8250 Dell Dimension 8250 Owner's Manual - Page 118
restore the correct settings in step 7.
View all Dell Dimension 8250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
www.dell.com | support.dell.com CAUTION: A new battery can explode if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions. 1 Record all the screens in system setup (see page 116) so that you can restore the correct settings in step 7. 2 Open the computer cover (see page 84). 3 Locate the battery socket labeled BATTERY (see page 118). NOTICE: If you pry the battery out of its socket with a blunt object, be careful not to touch the system board with the object. Ensure that the object is inserted between the battery and the socket before you attempt to pry out the battery. Otherwise, you may damage the system board by prying off the socket or by breaking circuit traces on the system board. 4 Remove the battery by carefully prying it out of its socket with your fingers or with a blunt, nonconducting object such as a plastic screwdriver. 5 Insert the new battery into the socket with the side labeled "+" facing up, and snap the battery into place. battery socket (BATTERY) battery 118 Appendix NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer. 6 Close the computer cover, and plug your computer and devices into electrical outlets. 7 Access system setup (see page 115) and restore the settings you recorded in step 1. 8 Properly dispose of the old battery (see page 14).