Dell Dimension 8250 Dell Dimension 8250 Owner's Manual - Page 96
Adding a Memory Module
View all Dell Dimension 8250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
www.dell.com | support.dell.com 4 Open the computer cover (see page 84). 5 Press out the securing clip at each end of the memory module connector. 6 Grasp the module and pull up. If the module is difficult to remove, gently ease the module back and forth to remove it from the connector. Adding a Memory Module 1 Shut down the computer (see page 33). NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack. 2 Turn off any attached devices and disconnect them from their electrical outlets. 3 Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board. 4 Open the computer cover (see page 84). 5 Press out the securing clip at each end of the memory module connector. 96 A d d i n g Pa r ts