Dell Dimension 8250 Dell Dimension 8250 Owner's Manual - Page 88
Installing and Removing Cards - network drivers
View all Dell Dimension 8250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
www.dell.com | support.dell.com Installing and Removing Cards CAUTION: Before you begin any of the procedures in this section, follow the steps in "When Working Inside Your Computer" on page 12. CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover. Your Dell™ computer provides slots for up to four 32-bit, 33-MHz cards. Cards If you are installing or replacing a card, follow the procedures in the next section. If you are removing but not replacing a card, see "Removing a Card" on page 92. Installing a Card CAUTION: Before you begin any of the procedures in this section, follow the steps in "When Working Inside Your Computer" on page 12. 1 If you are replacing a card, remove the current driver for the card from the operating system. 2 Shut down the computer (page 33). NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack. 3 Turn off any attached devices and disconnect them from their electrical outlets. 4 Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board. 5 Open the computer cover (see page 84). 6 Press the lever on the card retention arm and raise the retention arm. 88 A d d i n g Pa r ts