Dell Force10 E600i E600i System Installation Guide - Page 41

10 Using a Flash Memory Card This appendix provides information about using an external flash memory card and contains the following sections: • External Flash Memory Card Overview • Formatting an External Flash Card • Inserting the External Flash Memory Card • Removing the External Flash Memory Card • Copying Files to the External Flash • Displaying Files Stored on the External Flash External Flash Memory Card Overview Each RPM card is designed with a slot to accommodate an external flash memory card (slot0:). You can use a flash card to copy the image and configuration files for storage and backup purposes. For complex configurations, use the copies for other E-Series systems in your network. Configure your boot execution process to use the images stored on a flash card as the primary (active), secondary (standby), or default boot order preference. Optional external flash memory cards are shipped blank. Inserting the External Flash Memory Card NOTE: Only insert the external flash before system boot or after the system has completed its boot and is runtime mode. To install the flash memory card: Step Task 1 Press the ejector button to ensure it is in the extended position. Hold the flash card vertically (with the manufacturers able on the left and the barcode on the right). 2 Gently insert the flash card into the primary RPM flash slot until the is card is flush with the front panel. Do not force the flash card into the slot. 3 The In Use LED illuminates only during read or write operations. Removing the External Flash Memory Card To remove the flash memory card: Step Task 1 Extend the ejector button by pressing the ejector button. Then press the ejector button again to eject the memory card. 2 Remove the card and store it in an antistatic bag. Using a Flash Memory Card | 41